mBlock 5 Webpage

You can also use mBlock 5 on the web without downloading it.

mBlock 5 webpage: https://ide.mblock.cc

To connect a device to mBlock 5 on the webpage, you need to install mLink first.

Preparation for Installation

  • PC system:Windows 7 or later (64-bit systems recommended); macOS 10.10 or later; 64-bit Linux

  • Browser: Chrome recommended

  • mBlock 5 webpagehttps://ide.mblock.cc

  • Devices supported: Bluetooth Controller, Codey Rocky, HaloCode, mBot, MotionBlock, Neuron, mBot Ranger, Ultimate 2.0, Arduino Uno, Arduino Mega2560, Nova Pi, MegaPi Pro

Quick Installation

For Windows

1. Download mLink.

mLink-Windows installation package

2. Open the installation file and follow the installation wizard.

3. After the installation is complete, the mLink icon is displayed on the desktop and the toolbar in lower right corner.

For Mac

1. Download mLink.

mLink-macOS installation package

2. Open the installation file and follow the installation wizard.

3. After the installation is complete, the mLink icon is displayed on the launchpad and the taskbar in the upper right corner.

Method 1

1. Click OK.

图片

2. Choose System Preferences > Security & Privacy.

图片

3. Click Open Anyway.

图片

4. Start the mLink installation process.

图片

Method 2

1. Right-click the installation package and choose Open.

2. Click Open.

图片

3. Start the mLink installation process.

图片

For Linux

1. Download mLink.

Note:
Only 64-bit Linux OS is supported.

2. Install mLink through command lines.

_Install .rpm on Red Hat, Fedora, SUSE, CentOS

(1) Open Terminal, enter the following command, and press Enter:

sudo rpm -ivh --force mLink-1.2.0-1.el7.x86_64.rpm

(2) Enter the following command to start the program:

sudo mblock-mlink start

Note:
Do not close Terminal After opening the program. Otherwise, the device communication is disconnected.

Enter the following command to stop the program:

sudo mblock-mlink stop

Install .deb on Debian and Ubuntu

(1) Open Terminal, enter the following command, and press Enter:

sudo dpkg -i mLink-1.2.0-amd64.deb

(2) Enter the following command to start the program:

sudo mblock-mlink start

Note:
Do not close Terminal After opening the program. Otherwise, the device communication is disconnected.

Enter the following command to stop the program:

sudo mblock-mlink stop

Device Connection (Using Codey as an Example)

1. Use a USB data cable to connect your device and PC.

2. Ensure that the device is turned on.

3. Double-click the mLink icon on the desktop to run it.

Note:
If mLink runs on Windows for the first time, mLink, the following alert may be displayed. Click Allow access.

4. Visit the mBlock 5 webpage and click Connect to connect your device.

Note:
COM3 is a serial port number that varies according to system and PC. Use the default port number and click Connect.

results matching ""

    No results matching ""